edastudy:tessent:dft_signals
这是本文档旧的修订版！
目录
1. dft signals
table_1 table_2 table_3 list the pre-registered static DFT signals.
table_4 Table 4 lists the pre-registered dynamic DFT signals.
1.1 Table 1
| Pre-Registered Static Global DFT Control Signal Names |
|---|
| all_test |
| bscan_clamp_enable |
| bscan_input_isolation_enable |
| output_pad_disable |
| dft_signal_disable |
| occ_kill_clock_en |
| ssn_en |
| tck_occ_en |
| tck_select |
| tristate_enable_nc_test |
| tristate_enable_nc_test_type |
1.2 Table 2
| Pre-Registered Static Logic Test Control Signal Names |
|---|
| async_set_reset_static _disable |
| capture_per_cycle_static_en |
| control_test_point_en |
| ext_ltest_en |
| ext_lbist_en |
| int_ltest_en |
| lbist_en |
| lbist_low_power_shift_en |
| lbist_self_test_en |
| ltest_en |
| mcp_bounding_en |
| memory_bypass_en |
| observe_test_point_en |
| se_pipeline_en |
| wrapper_toggle_en |
| x_bounding_en |
1.3 Table 3
| Pre-Registered Static Scan Mode Signal Names |
|---|
| controller_chain_mode |
| edt_mode |
| ext_edt_mode |
| ext_mode |
| ext_multi_mode |
| ext_single_mode |
| int_edt_mode |
| int_mode |
| int_multi_mode |
| int_single_mode |
| multi_mode |
| promoted_cells_mode |
| retargeting#_mode = 1, 2, ...,8 |
| single_mode |
1.4 Table 4
| Pre-Registered Dynamic DFT Signal Names |
|---|
| async_set_reset_dynamic_disable |
| capture_per_cycle_dynamic_en |
| edt_clock |
| edt_update |
| input_wrapper_scan_en |
| lbist_async_set_reset_dynamic_enable |
| lbist_misr_accumulate_en |
| lbist_prpg_en |
| lbist_reset |
| output_wrapper_scan_en |
| scan_en |
| shift_capture_clock |
| shift_clock |
| capture_clock |
| test_clock |
1.4.1 async_set_reset_dynamic_disable
1.4.2 edt_clock
1.4.3 shift_capture_clock
1.4.4 shift_clock
1.4.5 capture_clock
2. wavefroms
edastudy/tessent/dft_signals.1700531334.txt.gz · 最后更改: 2023/11/21 09:48 由 zhangguo